IFS-10-PM programming & display unit
Unit Settings
Parameter
Min
Max Default
Display Mode
It sets which of the four display modes has to be
used as start display (see the “5 - Parametrization
of the safety unit” section on page 15).
1
Display 1: Frequencies (Hz), see on
page 16
2
Display 2: Divergence (%), see on page
16
3
Display 3: Scaled Input 1 for speed,
rotational speed, frequency …
visualization, see on page 16
4
Display 4: Scaled Input 2 for speed,
rotational speed, frequency …
visualization, see on page 16
1
4
1
Screen Light
It sets the brightness of the OLED display
*
.
0
Display brightness
minimum
…
99
Display brightness
maximum
0
99
0
Screen Saver
It sets the time expressed in minutes after which
the screen saver is activated
*
.
0
screen saver OFF
1
screen saver active after 1 minute
…
999 screen saver active after 999 minutes
0
999
1
PIN Value
It sets a PIN code for access. If you set “0000“ the
PIN request is not active. Any other value will be
used as PIN code at next power-on of the IFS-
10-PM display unit. For further information
please refer to the “5.9 Entering the pin value”
section on page 25.
0000
9999
0000
Touch Tones
This item is used to set whether the keypad tones
are active or inactive.
0
keypad tones
OFF
1
keypad tones
ON
0
1
1
MAN IFS-10-PM EN 1.1.odt
6 - IFS-10-PM parameters list
31/44
