AMM5A & AMM5B • SSI, BiSS, & RS-485
Step 6
Connect the
EC-DF19-LK-TF12-...
cable to the Hirose connector of the
encoder unit
5
. Please make sure that the power supply is off and the battery is
not wired before connecting the cable.
Step 7
Connect the battery.
Step 8
Switch the power supply on. The LEDs will blink for a while and then go off, if
the installation procedure is successful.
If at the end of the operation a LED is still on, please repeat the procedure again.
Refer also to the “9 - Diagnostic LEDs” section on page 51.
WARNING
Light alters significantly the proper operation of the system.
Please mount the motor cap and protect the encoder from light sources before
starting the system and checking its operation. The encoder has been calibrated
to perform at its best without any light interference.
MAN AMM5A_B SSI_BiSS_RS485 E 1.9.odt
3 - Mounting instructions
19 of 56
