AMM5A & AMM5B • SSI, BiSS, & RS-485
the enclosure of the encoder unit
5
does not hit or touch the code disk
3
;
always handle the encoder unit
5
by holding the enclosure on the sides.
Step 4
Insert the M2.5 x 6 cylinder-head bolts UNI5931
7
in the holes
6
, tighten both
bolts
7
down to firmly fix the encoder unit
5
, torque to
0.8 Nm
max. Hold the
encoder unit
5
down and avoid any movements while tightening.
Step 5
Rotate the motor shaft until the code disk
3
is aligned with the encoder unit
5
as shown in the Figure; the mark
8
punched in the code disk
3
must be centred
in the encoder unit
5
as shown in the Figure. Max. misalignment allowed: ± 10
mechanical degrees.
WARNING
If you do not align the code disk
3
with the encoder unit
5
, the encoder will
send back an error at power-on. Should this happen, switch the power supply
off, align the code disk
3
properly and then proceed again as explained in the
next step.
MAN AMM5A_B SSI_BiSS_RS485 E 1.9.odt
3 - Mounting instructions
18 of 56
