Page 64 / 113
Section 6. Web control
– Using the built-in website
6.10. Advanced view
Advanced view is the surface for LW3 protocol settings with terminal window. Commands
and specific parameters (that are not available on the user interface) can be run and set.
Detailed information about the protocol, nodes, methods and parameters can be found in
chapter
. Click on Close button to hide the Advanced view.
Figure 6-20. Advanced view
Terminal window
Commands and responses are listed in this window. The
timecode in every row shows the exact time when the command
was sent or the response received. Sent command is displayed
in red and starts with
‘>’ character, received response is
displayed in blue and starts with ‘<’ character. The content of the
window can be emptied by the Clear button.
Command line
Commands/queries can be typed directly into this field.
Send button:
Execute the command in the field.
Clear button:
Empty the terminal window.
Open terminal window: The separate window can show the
commands
and
responses
after
closing the advanced view.
Protocol tree
The protocol tree is available via this panel. Select an item to see
its content.
Node content
The properties and methods are shown which belong to the
selected node in the protocol tree.
Manual button:
Manual (short description) of the node can be
called and displayed in the terminal window.
See more information about manuals in
section
Set button:
Saves the value/parameter typed in the
textbox.
Call button:
Calls the method with the typed value, e.g.
reloads factory default settings.
Info: If a module is locked, its settings cannot be changed; parameters, values will not be saved,
and factory default settings cannot be reloaded.
3
1
2
4
1
2
3
4
