DA2DVI-Pro
User’s Manual Rev. 1.3
Page 31 / 43
Front panel control
Description:
The DA2DVI-Pro is set to be controlled via the USB port by SW1 of
the DIP switch.
Format:
←
(NOK)CrLf
4.10. Input and output port status
4.10.1.
Check the status of the inputs
Description:
Use this command to determine the actual status of the input port.
Format:
→
{:ISD}
←
(ISD
●
STATUS_TABLE)CrLf
Example:
→
{:ISD}
←
(ISD 00112333233300033330022000000000)CrLf
Legend:
0
PWR5V signal is not present on this input.
1
PWR5V signal is present on this input.
2
Active DVI signal is present at this input (data enable signal is
successfully recovered from the TMDS stream) but there is no
PWR5V.
3
Active DVI signal is present at this input (Data enable signal is
successfully recovered from the TMDS stream) with PWR5V.
4.10.2.
Check the status of the outputs
Description:
Use this command to determine the actual status of the output ports.
Format:
→
{:OSD}
←
(OSD
●
STATUS_TABLE)CrLf
Example:
→
{:OSD}
←
(OSD 00110111001100011100011000000000)CrLf
Legend:
0
There is no attached monitor
1
There is an attached monitor
Summary of Contents for DA2DVI-Pro
