DA2DVI-Pro
User’s Manual Rev. 1.3
Page 21 / 43
The process of emulating an EDID is the following:
1.
Select the
Emulated EDID List
in one of the list window areas in the drop-
down menu.
2.
Select the desired EDID from one of the list windows.
3.
Drag and drop the EDID to the desired location in the
Emulated EDID list
.
Info:
If the monitor’s EDID was selected to be emulated (DVI OUTPUT 1) the currently
emulated EDID will be changed on the input every time a new monitor is
connected. If the monitor is disconnected from the output, the last EDID remains
active, it will not be deleted from the input. This feature helps especially rental
technicians or system integrators to keep the source continuously transmitting the
signal, and adopt the system for new incoming display devices.
Info:
Power ON/OFF cycle will not affect the emulated EDID or other settings.
Info:
EDID switch procedure causes a status change and hence it is reported back to
the CONTROL SOFTWARE within 2-3 seconds.
Learn EDID from attached display device
The system is able to learn the EDID from the connected display device and store
it in one of the user programmable memory locations.
1.
Select
User Memory
in one of the list window areas in the drop-down menu.
2.
Select the EDID to be saved from the other list window.
3.
Drag and drop the selected EDID to the desired
User Memory
location.
Load EDID from file to memory
The DA2DVI-Pro is able to learn and store EDID from a file located on the
computer. EDID are stored in *.dat files.
1.
Select the
User Memory
list window from one of the drop-down menus, and
right click on the desired memory location. Then select “
Load from file
” from
the pop-up menu.
2.
Browse your hard drive to find the EDID file in the pop-up window. The
software checks whether the selected file is a valid EDID file.
3.
Click
Open
in the browser window. After the process finished, ”EDID Upload
completed” message appears.
Save EDID from memory to file
The control software is able to download EDID from the DA2DVI-Pro and to save it
as an EDID file.
1.
Right click on the EDID to be saved.
2.
Click on
Save to file
in the pop-up window.
3.
The Matrix Controller Software downloads the desired EDID and a save
dialog appears. It may take a few seconds to download the EDID. If the save
dialog is shown, type in the file name, and press Save button. After the
process was completed, an ”EDID saved!” message confirms the command.
Summary of Contents for DA2DVI-Pro
