OWNERS MANUAL
Page 4 of 5
7/²/,*+7,1*&2162/(
Revision 2.0
08/21/1999
Lightronics Inc.
509 Central Drive Virginia Beach, VA 23454
TEL 757 486 3588
*(1(5$/23(5$7,212)&21752/6
CROSS FADER:
The cross fader provides the ability to fade between the upper (X) faders and the lower
(Y) faders. The cross fader is split into two parts giving you the ability to control the level
of the upper and lower groups of faders individually. In all modes, the "X" cross fader
must be up to activate the upper faders and the "Y" cross fader must be down to
activate the lower faders.
MASTER:
The master level fader controls the output level of all functions of the console.
BUMP BUTTONS:
These momentary buttons activate channels 1 through 16 while pressed. The master
fader determines the level of channels activated by the bump buttons.
CHASE 1 & 2 BUTTONS:
Press to select chase patterns. Chase LEDs will light when a chase is active.
CHASE RATE BUTTON:
Press 3 or more times at the desired rate to set chase speed. Chase rate LED
will flash at the selected rate.
BLACKOUT BUTTON:
Pressing the blackout button causes all channels, scenes and chases to go to
zero intensity. The blackout LED will light whenever the console is in blackout
mode.
RECORD BUTTON:
Press to record scenes and chase patterns. Record LED will light when in
record mode.
5(&25',1*&+$6(6
1)
Press the "RECORD" button, the record LED will flash.
2)
Press the "CHASE 1" or "CHASE 2" button to select a chase to record.
3)
Bring the channel(s) you want to be on in this step to full.
4)
Press "RECORD" to move to the next step.
5)
Repeat steps 3 and 4 until all steps are recorded (up to 23 steps).
6)
Press the "CHASE 1" or "CHASE 2" button to stop recording.
&+$6(3/$<%$&.
1)
Press the "RATE" button 3 or more times at the desired rate to set the chase speed.
2)
Press "CHASE 1" and/or "CHASE 2" to turn chases on and off.
Note: Both chases may be on at the same time. If chases have a different number of steps, complex, changing
patterns can be created.
5(&25',1*6&(1(6
1)
Choose either operating mode and create the scene to be recorded.
2)
Press "RECORD".
3)
Press the bump button below the fader you wish to record the scene to.
Note: Scenes may be recorded even if blackout is on or the master fader is down. Scenes may include other scenes
if recorded while in the "SCENE 1-16" mode. This allows you to copy from one scene to another to move it or create
modified versions.
