OWNERS MANUAL
Page 2 of 5
7/²/,*+7,1*&2162/(
Revision 2.0
08/21/1999
Lightronics Inc.
509 Central Drive Virginia Beach, VA 23454
TEL 757 486 3588
63(&,),&$7,216
Number of channels
32 or 16 depending on mode
Operating modes
16 channels x 2 scenes
32 channels x 1 scene
16 channels and 16 recorded scenes
Scene memory
16 scenes total
Chase
2 programmable 23 step chases
Control protocol
LMX (3 pin multiplex) (Optional DMX-512)
Output connector
3 pin mic. XLR connector (5 pin mic. XLR for DMX-512)
Compatibility
Multiplex protocol compatible with other 3 pin multiplexed systems
Power input
18VAC or 15VDC (Optional external power supply)
Power consumption
70ma
Other features of the TL-3216 include: Grand master fader, split dipless crossfader, momentary "bump" buttons, and
blackout control. Both 23 step chases may be activated simultaneously for complex patterns. Chase rate is set by
tapping the rate button at the desired rate. The TL-3216 also offers the ability to link with a second TL-3216 console or
a TL-1608 console for increased capacity using a single multiplex control cable.
,167$//$7,21
The TL-3216 control console should be kept away from moisture and direct sources of heat.
Connect the unit to a Lightronics (or compatible) dimmer using a multiplex control cable with 3 pin XLR connectors.
The TL-3216 is powered by the dimmer which it is connected to. It may also be powered via an optional external
power supply. The unit will operate with dimmers in both the NSI/SUNN and Lightronics modes. All dimmers
connected to the unit MUST be in the SAME mode.
To reset chases to the factory programmed defaults: Remove power from the unit. Hold down the CHASE 1 and
CHASE 2 buttons. Apply power to the unit while holding these buttons down. Continue to hold down the buttons for
approximately 5 seconds then release.
To reset scenes to the factory programmed defaults: Remove power from the unit. Hold down the RECORD button.
Apply power to the unit while holding this button down. Continue to hold down the button for approximately 5 seconds
then release.
You should check the address settings of the dimmers before proceeding with TL-3216 operation.
&21752/6$1',1',&$7256
"X" faders:
Control individual channel levels
"Y" faders:
Control level of scenes or individual channels depending on current operating mode
Cross fader:
Fade between "X" and "Y" faders
Bump buttons:
Activate associated channels at full intensity while pressed
Chase select:
Turn chases on and off
Chase rate:
Press three or more times at desired rate to set chase speed
Mode indicator:
Indicates current operating mode of "Y" faders
"Y" function select:
Selects operating mode of "Y" faders
Blackout button:
Turns on and off console output from all scenes, channels and chases
Blackout indicator:
Lighted when blackout is active.
Grand master:
Adjusts output level of all console functions
Record button:
Used for recording scenes and chase patterns
Record Indicator:
Flashes when Chase or scene recording is active.
