Lighthouse REMOTE 3012PN, Operating Manual, Page: 27 / 58

Getting Started
248083310-1 Rev 3 3-5
1. For information on how to use the Program Port to change the
instrument settings, please refer to “Programming” on page 4-1.
Data Cable Install
WARNING:
Make
sure the data cable is
NOT attached to the
monitoring device before
it is connected to the
REMOTE-2 PN. Power to
the REMOTE should be
ON when connecting to
the device.
Best practices dictate that power to equipment on both ends of the data
cable should be OFF before a cable is attached. This may not always
be practical, especially if a Lighthouse SIU or other equipment is
monitoring devices around the clock and service cannot be interrupted.
If the Rxxx2PN is involved in a new installation, power should be OFF
at both ends, cables installed and power applied to the Rxxx2PN then
the monitoring device. If power cannot be removed from the
monitoring end, make sure the Rxxx2PN is powered ON before
connecting the data cable.
Energize Connections
1. Connect the signal cable to the hub or data-gathering equipment.
2. Connect the ’PN’ AC Power cord to the AC source.
3. Apply AC power using the switch on the bottom left side.
4. Power should be applied to the instrument, indicated by the Rxxx2
Power LED illuminating. If the pump jumper wire is installed prior
to power ON, the pump should start running; otherwise, turn ON
the pump remote switch. After approximately twenty seconds, data
will be supplied by the REMOTE-2 PN to data monitoring
equipment or network.