Lighthouse REMOTE 3012PN, Operating Manual

Page: 25 / 58

Getting Started
248083310-1 Rev 3 3-3
Mount
REMOTE-2
PN Series
The REMOTE-2 PN Series use a standard NEMA footprint and
mounting to a flat vertical surface is required for proper operation.
Pump flow control is managed by the REMOTE-2 PN Series pump
controller. Power to the REMOTE-2 PN Series is managed by a power
switch inside the NEMA enclosure. The cover lock uses a flat blade or
coin to turn the latch to the open or closed position. Do NOT apply
power to the REMOTE-2 PN Series until cables are attached properly
at both ends.
Sample tubing runs should terminate at the instrument location and
should use Bevaline tubing to prevent static and particle dropout. The
REMOTE-2 PN Series instrument supports remote monitoring when
equipped with a tubing kit of 3 meters.
If the Inlet tubing is run over walls or around corners, keep the bend
radius greater than ninety degrees and three feet.
Do not patch sections together and keep the tubing supported to prevent
sagging and kinking over time.
Typical installations use a short length of tubing and a barbed ISO
probe that is either handheld or supported on a tripod.
Connecting the tubing to the instrument Inlet requires removing the cap
from the Inlet connector and installing the ferrule and nut assemblies
on the tubing as shown in Figure 3-3. This may be done with the Outlet
connector, as well, if the pump output requires that it be exhausted to
another area. The procedure is the same for the Outlet. Review the
photos in Figure 3-4 and Figure 3-5.
Figure 3-3 Nut and Ferrule Installed on Tubing