Lighthouse Remote 2014P, Operating Manual

Page: 27 / 80

Unpacking, Inspecting and Installing
248083408-1 Rev 1 3-7
WARNING:
Wiring
the pins in reverse order
may harm the instrument
and/or the sensor and
may void their respective
warranties.
If you are wiring a cable to use with a sensor from another
manufacturer, the connectors on telephone cables are mirror images of
each other. For that reason, we have not included color coding in the
table. The figure below shows the pin numbering on the back of the
REMOTE - your cable must be wired accordingly.
Figure 3-4 Analog Sensor Ports, Showing Pin Numbering
Note that the ports are oriented with the locking tabs at the side.
DIP Switches
DIP switches 1-6 are used for addressing the instrument for RS-485
and setting the Communications Mode.
DIP switch 7 enables or disables the Remote LCD Display option. See
Chapter 4 for more details.
Power
WARNING:
If the
REMOTE will be used
with the Lighthouse
MiniManifold, do NOT
use the REMOTE 24VDC
power supply - power
will be supplied through
the signal cable from the
MiniManifold; otherwise,
damage to either unit
may occur.
This REMOTE instrument uses an external power supply rated at
+24VDC at 0.62A. The connector incorporates a threaded ring to lock
it into position, preventing accidental disconnects.
Power Switch
The ON/OFF switch controls power to the instrument.
Pin 1
Pin 6