END MOUNT INSTALLATIONS
END (INSIDE) MOUNTS OVER RECTANGULAR SHADE:
For end mounts the specialty end brackets will be screwed in place through the two
holes of each bracket. These are used for inside mount side-surface areas and will
typically be installed over an end (inside) mounted rectangular shade. Refer to the
minimum surface height chart below.
End Mount Surface Height Requirements
NOTE: Prior to mounting the brackets, remove the plastic end-caps from each end of
the arch bottom rail. The end brackets will slide into the open ends of the bottom rail.
MARK THE BRACKET POSITIONS:
Slide the end mount brackets into the open ends of the arch bottom rail.
Hold shade up and mark positions or …
Place arch bottom rail onto rectangular shade headrail, align and mark positions.
INSTALL THE SHADE (MOUNT THE BOTTOM RAIL):
Screw end brackets through two holes to desired location.
MARK AND ATTACH THE TOP BLOCK POSITION(S): 1 AND 2-STRING SHADES
See INSIDE MOUNT instructions for TOP BLOCKS (above).
NOTE: SEE INSIDE MOUNT 1-STRING OR 2-STRING DIAGRAM ( FIGURE 1 OR 2 ).
FOR SHADES WITH MONOFILIMANT GUIDES
For shades with monofilament guides, the line needs to be straight when the screw is
tightened all the way. The screw will be secured to the window opening.
Bracket Size
Minimum Height
3/8” Bracket
7/8”
3/4” Bracket
1”
