OUTSIDE MOUNT INSTALLATIONS
For outside mounts the standard installation brackets will be screwed in place through
the two back holes of each bracket. Refer to the minimum surface height chart below.
Outside Mount Surface Height Requirements
MARK THE BRACKET POSITIONS:
Mark where the ends of the headrail will be positioned. Either…
Hold shade up and mark positions or measure bottom rail and mark width.
Then mark 3” in from the bottom rail end-marks for the installation brackets.
ATTACH THE BRACKETS:
Screw standard brackets through two back holes.
SPACER BLOCKS (optional):
Spacer blocks will be attached to the end of each bracket.
Ensure the screws are long enough to secure brackets to surface.
Do not use more than three spacer bocks per bracket.
If installing extension brackets, do not use spacer blocks.
EXTENSION BRACKETS (optional):
Position the extension brackets to the desired wall location.
The bracket tops must be aligned and level to one another.
Mount the extension brackets through the back holes.
Attach the installation brackets to the extension brackets.
Use the same holes for all brackets to ensure an even projection.
MARK THE TOP BLOCK POSITION: 1-STRING SHADES
Place a mark at the top center of the window opening.
INSTALL THE SHADE (MOUNT THE BOTTOM RAIL):
With the front (colored) side of the shade facing you …
Tilt the bottom rail slightly forward to angle the back inside lip to the brackets.
Rotate bottom rail upward to snap into place.
Bracket Size
Minimum Height
3/8” Bracket
5/8”
3/4” Bracket
1”
