To REMOVE shade, maintain hold on shade and loosen tabs with screwdriver.
ATTACH THE TOP BLOCK: 1-STRING SHADES
Align the groove of the top block with the center mark.
Ensure the front of the top block is aligned with the front of the shade.
NOTE: DO NOT position the top block so that the screw hole is center.
Ensure that the screw hole is 3/8” off center.
Screw the top block in place. Before tightening all the way …
Loop the shade cord into the top block groove so that the top half of the joiner
ball is coming out of the front of the top block.
MARK THE TOP BLOCK POSITIONS: 2-STRING SHADES
Place a mark at the top center of the window opening.
Measure the distance between the two cords coming out the top cell of the shade.
NOTE: the distance was determined by the curvature in the arch.
At the top of the arch opening, mark to the left and right of the middle mark …
These marks correspond to the distance each cord is left and right of center.
ATTACH THE TOP BLOCKS: 2-STRING SHADES
The center top block is already attached to the cords..
Screw the center top block in place ...
Ensure that the groove for the cords is centered over the eyelet on the bottom rail.
Screw the outer top blocks to the frame/bracket. Before tightening all the way …
Loop the left and right cords into their corresponding grooves and then tighten.
NOTE: SEE 2-STRING DIAGRAM UNDER INSIDE MOUNTS ( FIGURE 2 ).
Tab Screw
Bottom Rail
Make sure the Top
Block is positioned
so that the cords are
straight and plumb.
FIGURE 3
