MOUNTING BRACKETS - OVERVIEW
Swivel installation brackets will be used for normal INSIDE mounts. Standard
installation brackets will be used for all OUTSIDE mounts. End installation brackets
will be used for END (SIDE) mounts when arches are installed over rectangular
shades. [NOTE: for each of these bracket types, there is a small size (for 3/8”
honeycomb shades) and a large size (for 3/4" and 1/2" honeycomb shades).
Mounting the brackets level is essential for proper operation of the shade.
The swivel and standard bracket requirements and placements are the same for
inside and outside mounts. Mount installation brackets 3” from each end of the
shade. Space any additional brackets evenly. Refer to the following spacing
diagram and bracket requirement chart.
BRACKETS space 3” from ends
Installation Bracket Requirement Chart – Swivel & Standard
Specialty end-mount brackets will be installed just off the shade ends for inside
mounts onto a recessed surface area above a rectangular shade. The maximum
shade width for this installation type is 48” and only 2 brackets will be used.
Installation Bracket Requirement Chart – End
Shade Width
Brackets Required
18” to 40”
2
40-1/8” to 72”
3
72-1/8” and over
4
Shade Width
Brackets Required
18” to 48”
2
