Re Fitness Collection
9
8
Waver Micro User Manual Lifepro
ACTIVATE THE REMOTE CONTROL
• The battery compartment is located on the
bottom of the remote control. Press the tab in
and pull the compartment out to remove it.
• Insert one CR2025 battery into the battery
compartment as shown. Battery terminals are
polarized, so make sure to insert the battery with
the + side facing up.
• Replace the battery compartment inside the remote
control by pushing it in until it snaps securely in
place.
ATTACH THE TWO RESISTANCE BANDS
The resistance bands let you incorporate strength
training into your workout.
• Locate the two short black metal bars under the
front edge of the unit.
• Swivel each bar so it extends out the front of the
unit.
• Loop the end of a resistance band through one of
the metal bars.
• Thread the resistance band handle through the
loop and pull tight.
• Attach the second resistance band to the metal
bar on the opposite side in the same manner.
CONNECT TO POWER
• Insert the power cord firmly into the power cord
jack at the front of the unit.
NOTE:
Press forcefully until you feel a click, which
indicates that the cord is securely connected.
Power cord fits tightly so it will not loosen during
use.
• Plug the power cord into an AC outlet.
POWER ON THE WAVER MICRO
• Flip the Power switch to the ON position.
Setup your Waver Micro in just four easy steps:
3
4
2
1
4 Mini
Bands
Lifepro Waver Micro
Vibration Plate
Exercise Mat
Remote
Control
Power
Cord
2 Resistance
Bands
Your Waver Micro is now ready to use. See OPERATING INSTRUCTIONS
and CREATING A WORKOUT on the next pages for details.
