14
Swift User Manual Lifepro
Re Fitness Collection
15
POWER ON THE SWIFT
1. Plug the power cord into a grounded wall outlet.
2. Flip the Power switch at the front to the ON position. The
display will light up and all values will be set to zero.
POWER OFF AND UNPLUG THE SWIFT
1. Remove the magnetic safety key and store it in a separate location.
2. Flip the Power switch to the OFF position.
3. Unplug the power cord from the wall outlet.
2
1
GET ON THE TREADMILL
1. Hold onto the handrails with both hands.
2. Stand with your feet on the foot rails on either side of the running belt.
Do not stand on the running belt.
3. Press the green
Start button
.
4. Place your feet, one at a time, on the running belt only
after
it has begun
to move at a consistent, low speed of 2 mi/hr or less
.
GET OFF THE TREADMILL
1. Press the red
Stop button
to stop the running belt.
2. Wait until the treadmill has come to a
complete stop
before
attempting to get off the treadmill.
3
2
1
PLACE THE MAGNETIC SAFETY KEY
The magnetic safety key cuts power to the treadmill if you fall or an
emergency occurs. See
USING THE MAGNETIC SAFETY KEY
on page 9.
1. Place the magnetic end of the safety key on the round magnetic port
just below the control panel on the treadmill console.
2. Clip the other end of the safety key securely to your clothing.
3. Give the clip a tug to make sure it won’t release from your clothing.
The magnetic key MUST be in place before the treadmill can be operated.
STARTING THE TREADMILL
STOPPING THE TREADMILL
Off Position
On Position
INSTALL THE DISPLAY PANEL
You will need:
display panel, 3 M6×40mm Phillips-head screws
(D)
,
multi-tool
(A)
5
M6×40mm
Screw (3)
Phillips
Screwdriver End
of Multi-tool
LUBRICATE THE RUNNING BELT
Before using your Swift treadmill for the first time, you must
lubricate the running belt. Follow the steps in
LUBRICATING THE
RUNNING BELT
on page 32.
6
1. Connect the three wires exiting
the bottom of the display panel
to the corresponding wires exiting
the top of the console at the
front of the control panel.
2. Align the three screw holes on
the bottom of the display panel
with the three screw holes on the
front of the console.
3. Insert a Phillips-head screw
(D)
through the center screw hole
from the underside of the console
and into the bottom of the display
panel.
4. Tighten the screw using
the screwdriver end
of the multi-tool
(A)
.
5. Repeat steps 3-4
for the left and
right screw holes.
