INSTALL THE WHEEL BRACKETS
You will need:
2 wheel brackets, 4 M8×45mm screws
(G)
,
4 washers
(E)
, 4 lock nuts
(F)
, multi-tool
(A)
, wrench
(B)
Re Fitness Collection
11
LAY OUT THE TREADMILL,
PARTS, AND HARDWARE
1. Place the folded treadmill body
on the floor.
2. Place all parts, tools,
and hardware
nearby.
ASSEMBLY NOTES
• Assemble the Swift on flat, clean floor, free of obstructions.
• Ensure you have at least a 6-by-6-foot space to complete the assembly.
Assembly requires two people; the treadmill is heavy and bulky.
SAFE PLACEMENT OF YOUR SWIFT TREADMILL
• Only operate and store the Swift on a flat, non-slip floor.
• Ensure the running deck is level to the ground. If the deck is positioned on an
uneven surface, it could cause damage to the electrical system.
• Set up with at least 7 feet of clearance from walls and furniture at the back
and at least 4 feet of clearance at the front and sides of the treadmill.
• Do not use outdoors or in high-moisture or high-temperature environments.
• If setting up in a carpeted room, check underneath the treadmill to ensure
clearance between the carpet and the running deck. If there is not enough
clearance, or you’re not sure, place a mat or rug under the Swift. Ensure the
mat or rug is at least 60” × 36” and will not slip during use.
• Sometimes after an extended amount of use, you will find a fine black dust
under the treadmill. This is normal wear and does not mean there is anything
wrong with the treadmill. The dust can be easily vacuumed up. If you wish to
prevent the dust from getting on your flooring or carpet, place a mat or rug
under the treadmill.
2
1
10
Swift User Manual Lifepro
Re Fitness Collection
11
1. Tip the treadmill body onto the
non-slip feet under the front of
the motor housing. The running
deck and handrails will point
UP
.
2. Align one of the wheel brackets
with one set of screw holes on
the wheel bracket support bar.
3. Put a washer
(E)
onto one of the
screws
(G)
.
4. Insert the screw/washer
combination through the screw
holes in the wheel bracket and
the support bar.
5. Screw a lock nut
(F)
onto the end
of the screw.
6. Repeat steps 3–5 to attach the
other side of the wheel bracket.
7. Attach the second wheel bracket
to the support bar in the same
manner.
8. Use the hex key end of the
multi-tool
(A)
to hold each screw
in place as you use the wrench
(B)
to tighten all four nuts.
M8×45mm
Screw (4)
Wrench
Wheel
Bracket (2)
Wheel
Bracket (2)
Motor Housing
Handrail
Running
Deck
Wheel Bracket
Support Bar
Hex-Key
Side of
Multi-tool
Washer (4)
Lock
Nut (4)
