47
2
25
23
3/8 X 1-1/4”
33
28
48
27
23
3/8 X 1-1/4”
6
5
STEP 9:
FIGURE 9
10
STEP 10:
•
LOOSELY
assemble the PILLOW BLOCKS (33) on the LEFT PIVOT ARM (5) to the CROSS SUPPORT (6) and the PIVOT ARM
SUPPORT (2) using four 3/8 X 1-1/4” BUTTON HEAD CAP SCREWS (23), four 3/8” SAE WASHERS (27), four RH WASHERS
(28), four STARLOCK WASHERS (47), four 3/8” LOW HEIGHT LOCK NUTS (25) and four RH CAPS (48) as shown in FIGURE
10.
FIGURE 10
33
5
• Slide two PILLOW BLOCKS (33) over the LEFT PIVOT ARM
(5) and
LIGHTLY
tighten the set screws on the PILLOW
BLOCKS (33) as shown in FIGURE 9.
•
LOOSEN
set screws on the PILLOW BLOCKS (33) on the LEFT PIVOT ARM (5) & RIGHT PIVOT ARM (4).
Rotate both PIVOT
ARM (4 & 5) so that they contact each other and line up.
TIGHTEN
the PILLOW BLOCKS (33) on both PIVOT ARMS (4 & 5)
and to the CROSS SUPPORT (6) and PIVOT ARM SUPPORT (2). Adjust the PIVOT ARMS (4 & 5) up or down so that both arms
are the same height.
TIGHTEN
all PILLOW BLOCK (33) set screws.
TIGHTEN!
4
6
4d
