STEP 13:
FIGURE 13
13
25
55
48
10
4
•
CAREFULLY
route the CABLE around both the 4-1/2” PULLEYS (10) on the RIGHT PIVOT ARM (4) as shown, and assemble the end
of the CABLE to the CROSS SUPPORT (6) using two RH CAPS (48), one 3/8 X 1-3/4” BOLT (55), two 3/8” RH WASHERS (28) and one
3/8” LOW HEIGHT LOCK NUTS (25) as shown in FIGURE 13.
(NOTE: Make sure the CABLE runs in the grooves of all PULLEYS.)
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
6
28
CABLE
3/8 X 1-3/4”
•
SECURELY
tighten the BOLTS connecting the PULLEYS to the RIGHT PIVOT ARM (4).
(NOTE: Orientate both CABLE
CLIPS (53) as shown.)
• Assemble two 1 X 1” GLIDES (11) to the tube on the CROSS SUPPORT (6) where the RIGHT PIVOT ARM (4) contacts the tube on both
sides as shown in FIGURE 13.
11
53
53
