STEP 18:
•
Assemble the ROD END BEARINGS (50) to the 3/8”
THREADED RODS (49) so that a 2-7/8” gap exists
between the end of the ROD END BEARINGS (5) as
shown in FIGURE 18.
(NOTE:Make sure each
THREADED ROD (49) is screwed into each ROD END
(50) equally.)
FIGURE 18
50
49
2-7/8”
FIGURE 19
3/8 X 3-1/4” 22
25
27
31
48
50
28
5
4
STEP 19:
•
SECURELY
assemble the ROD END BEARINGS (50) to the RIGHT PIVOT ARM (4) using two RH CAPS (48), one 3/8 X 3-1/4” BOLT
(22), two 3/8” SAE WASHERS (27), two 3/8” RH WASHERS (28), one 3/8 X 1/4” SPACER (31) and one 3/8” LOW HEIGHT LOCK NUTS
(25) as shown in FIGURE 19.
•
SECURELY
assemble the ROD END BEARINGS (50) to the LEFT PIVOT ARM (5) using two RH CAPS (48), one 3/8 X 3-1/4” BOLT (22),
two 3/8” SAE WASHERS (27), two 3/8” RH WASHERS (28), one 3/8 X 1/4” SPACER (31) and one 3/8” LOW HEIGHT LOCK NUTS (25)
as shown in FIGURE 19.
17
10X
(NOTE: About 10 complete
revolutions each end)
10X
