• Finish assembling the HANDLE (13) to the RIGHT PIVOT ARM (4) using one 1/2 X 3-1/4” SHOULDER BOLT (24), two 1/2”
FLANGE BEARINGS (37), one 3/8” LOCK WASHER (29), and one 3/8” ACORN NUT (26) as shown in FIGURE 16.
(NOTE: Tighten
enough to allow HANDLE to lift up freely without sticking.)
16
STEP 16:
FIGURE 16
29
26
13
4
1/2 X 3-1/4” 24
TIGHTEN
SPRING PIN NUT
• Insert the SPRING ASSEMBLY on the HANDLE (13) into the HOUSING on the RIGHT PIVOT ARM (4). Thread the nut into the
HOUSING and tighten
SECURELY.
37
HOUSING
SHOULDER
BOULT
STEP 17:
FIGURE 17
•
SECURELY
assemble two FOOT SUPPORTS (14) to the RIGHT and LEFT PIVOT ARMS (4 & 5) using four RH CAPS (48),
four BLACK RH CAPS (54), four 3/8 X 2-1/2” (56), eight 3/8” RH WASHERS (28) and four 3/8” LOW HEIGHT LOCK NUTS
(25) as shown in FIGURE 17.
(NOTE: Make sure FOOT SUPPORTS (14) line up VERTICALY before tightening. SEE INSET.)
56
14
28
54
25
5
4
48
3/8 X 2-1/2”
LINE UP!
