Page | 7
Step 4:
Tools Needed:
6mm Allen wrench: 2JC7
1) Locate bag labeled Figure 4.
Note: Additional help may be needed to help
align holes on top and bottom.
2) (See Figure 4) Lift and place left linkage
handrail assembly onto shaft sleeve.
Make sure all four bolts line up. Screw
Qty. two M8x12mm hex bolts to the top
and bottom holes. Using a 6mm Allen
wrench, tighten the bolts.
3) Repeat same steps for right side.
Step 5:
Tools Needed:
17 mm socket wrench: 2JAX
17 mm wrench: 2JAW
Tube of grease: 2K81
Note: It is recommended that two adults help
align and secure the pedal tube assemblies to
the handrail assemblies.
Note: Apply about a finger tips worth of
assembly grease on each pivot point bolt
shaft and bearings prior to connecting arms.
1) Locate bag labeled Figure 5.
Note: Please ensure that pedal arm is aligned
in the center of roller wheel while tightening all
hardware. Repeat for the left side.
2) (See Figure 5) Locate right pedal tube
assembly and secure to the handrail
assembly with Qty. one M10x81.5 hex
bolt and Qty. one M10x1.5 hex nut. Using
a 17 mm socket wrench & 17 mm wrench,
tighten the bolts.
