Page | 20
Care and Maintenance
The LifeCore CD400 is made from the best materials and has been tested and received a quality
control review prior to its packaging to ensure the correct parts and proper fitting of each component.
This machine was designed to limit the amount of assembly needed by a customer. The amount of
maintenance required is very little and very simple; however, a failure to implement preventative
maintenance suggestions can prevent the machine from operating as designed. The CD400 is only
for indoor use and should not be stored in damp, extremely cold or hot areas as this will damage the
unit this voiding the warranty.
Rules:
Never
use WD-40 or any type of silicone spray to lubricate any moving parts. Use
appropriate lithium assembly grease as needed to the pivot points if noise occurs.
Always clean the machine after use.
1) Proper cleaning is important for longevity of a machine, clean the unit with a light soap
water mixture, follows by a dry towel, or uses a light house hold cleaner such as Windex
to remove dirt. The purpose of cleaning the unit is to remove body sweat which contains
salt. Salt is the number one factor that will cause the unit to rust and the electronics to
stop working.
2) Dry the unit off with a clean towel to remove left over moisture after every use.
After the first 12 hours of use, check and retighten any bolts, nuts, screws, pedals, etc.
making sure that they are tight and working properly.
1) The number one service issue is loose hardware. Loose hardware can cause the unit to
tick, creak, thump, knock, etc. After the first 12 hours once all the hardware has been
tightened, the hardware should be checked every 3 months.
2) Apply multi-purpose grease onto the bottom of both foot pedal tubes in the area that
makes contact with the roller wheel. (Parts # 2CU8 Shaft Wheel w/ball bearing) This
allows the wheel to roll smooth on the pedal tube.
Only use the appropriate power source, never use an adapter that is not certified for the unit,
a wrong adapter will cause the electronics to overheat and malfunction. AC Adaptor DC 9V
1000MA
In the unlikely event that the CD400 experiences a problem, please contact LifeCore fitness for
advice toll free at 888-815-5559.
