Page | 8
Step 7: Console Assembly
1) (
See Figure 7
) Connect console wire
(A8) and heart rate wires (E4) to the
console. Make sure that the wires are
connected together properly.
2) Slide the console onto the housing
covers. Be careful not to pinch the wires
while sliding the console. Push and
store excess wires back into housing
covers.
Step 8: Saddle & Saddle Tube Assembly
1) Remove knob (G3) and washer (G4)
from saddle (J).
2) Position
saddle
onto
the
moving
basement and tighten it using washer
(G4) and knob (G3).
3) Loosen knob (A11) on the saddle tube’s
receiver and pull on the knob to slide the
saddle tube (G) onto receiver. Once it is
locked in place, release the knob to
secure the saddle tube.
Figure 7
Figure 8