Life Fitness LS 9100, Service Manual

Page: 35 / 93

Life Fitness 9100/9500HR Belt Drive Stairclimbers
12
DIAGNOSTIC MODE
(Small Display)
ACCESS AND EXECUTION
Diagnostic State 2 – LED Test
This test will show the LED’s for each display segment for proper illumination.
Press Start/Enter key to scroll forward to Diagnostic State 3 or press the Clear/Pause key to scroll backward to
Diagnostic State 1.
Diagnostic State 3 – Program Version Number
The current Program Version Number will be displayed in the Time window. While pedaling the RPMs will be displayed
in the RPM window. And while holding the handrails the Heart Rate will be displayed in the Level window.
The Field Duty Cycle Load Test is displayed in the Calorie / Hour window. The greater the number, the higher the
resistance will be. To test in increments of one, press the DOWN arrow key to decrease resistance or the UP arrow
key to increase. To adjust in increments of ten (LS 9500HR ONLY) press the number 4 key to decrease the
resistance or the number 6 to increase.
Press the Start / Enter key to scroll forward to Diagnostic State 4 or press the Clear / Pause key to scroll backwards
to Diagnostic State 2.
Diagnostic State 4 – Network Status
The monitor version number of the heart rate board software is displayed in the Elapsed Time window.
The heart rate version number of the heart rate board software is displayed in the speed window.
The status of the Lifelink board and lifecenter connections are displayed in the Calorie / Hour window. The following
conditions are as follows.
Cal/Hour Description
None No Lifelink board detected
Null Board detected but not responding
On Linked to Lifecenter
Off Linked to Lifecenter
Press the Start / Enter key to scroll forward to Diagnostic State 5 or press the Clear / Pause key to scroll backwards
to Diagnostic State 3.