LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
866-‐471-‐7464
www.lifanpowerusa.com
23
Maintenance
MAINTENANCE SCHEDULE
PROCEDURE
TIME
Engine Oil Check
Each Use
Replace Engine Oil
After Each 40 Hours of Use (For Initial Break
in – After First (1
st
) 10 Hours of Use
Air Cleaner Filter
Check Each Use/Replace As Needed or After
Every 100 Hours of Use
Impeller Check
After 300 Hours of Use or After First Year
Air Cleaner Wash
When Needed
Spark Plug
When Needed
Valve Clearance
Check & Re-‐adjust annually or after 300
Hours of Use
Fuel Tank
Replace Every 3 Years Based on Condition
NOTE:
Refer to Following Procedures for Proper Method to Perform Maintenance
ENGINE OIL CHANGE PROCEDURES:
Periodic Maintenance of your engine oil should be performed after each 40 hours of
use of you Power Equipment Product. Check your engine oil level prior to each use.
1.
Start your engine and let it warm up to get the oil warm and thinner. Remove
the dipstick (Refer to Controls and Features section) by turning counter
clockwise. Remove the oil drain plug (Refer to Controls and Features section)
located below the dipstick utilizing the appropriate tools.
CAUTION: THE OIL MAY BE HOT.
2.
Drain the engine oil into an approved receptacle and discard in accordance with
all Federal and State Regulations. Never dump your used engine oil on the
ground or into drains, only discard in an approved manner. Check with your
local authorities to determine the regulations in your area.
WARNING! AVOID SPLASHING OF HOT OIL; IT CAN BURN YOU AND CAUSE
SEVERE INJURY.
3.
After oil is completely drained, replace oil drain plug and tighten with
appropriate tools. Replace oil with the proper oil for your product. Refer to the
Pre-‐Operating Instructions: Engine Oil Level Check section for exact fill
requirements. Always use your dipstick to check the oil level and only fill to the
full mark on the dipstick. Never overfill the engine, as this can cause damage to
the unit and void warranty.
