LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
866-‐471-‐7464
www.lifanpowerusa.com
11
Pre-‐Operating Instructions: Assembly
(continued)
UNPACKING THE GENERATOR:
1.
Set the carton on a flat, rigid surface.
2.
Remove all loose contents from carton EXCEPT the Engine/Pump portion of
pressure washer and set them beside carton.
3.
Open box completely by cutting each corner from top to bottom.
4.
Leave Generator on the remainder of the box until Wheel Kit is installed.
5.
Locate all box contents and place them beside the pressure washer. (Some Items
may be packaged within the voids of the pressure washer itself.)
INSTALLATION:
The Following Tools are needed to assemble the Pressure Washer:
•
Safety Glasses
•
8mm-‐14mm Wrench Set
•
8mm-‐14mm Ratchet & Socket Set
•
18mm Ratchet & Socket
HANDLE INSTALLATION:
1.
Slide both ends of Handle into the two poles located behind the engine. The
Handle should bend away from the water pump/engine.
2.
Insert Handle Bolt through the holes of the handle and pole. Fasten with 3-‐point
wing nut. The Wing Nut should be on the outside of the handle. The head of the
Handle Bolt should fit flush again the inside of the handle.
3.
Repeat Step 2 for the other side of the handle.
