LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
866-‐471-‐7464
www.lifanpowerusa.com
12
Pre-‐Operating Instructions: Assembly
(continued)
WHEEL KIT INSTALLATION:
Wheels are installed under engine; Support feet are
installed under pump end of base.
NOTE: Install Wheel Kit BEFORE Filling the Pressure Washer with Fuel or Oil. Never Tip
a Unit that contains Fuel or Oil.
1.
Carefully tip pressure washer so the Handle is touching the ground and the pump
is facing the sky.
2.
Using two 12mm Bolts, attach one Heavy-‐Duty Support Leg to the base of
pressure washer. Securely tighten using 12mm Ratchet and Socket or like tools.
3.
Repeat Step 5 to attach the second Heavy-‐Duty Support Leg.
4.
Carefully tip the pressure washer so the back of the handle is facing the sky and
the pump is facing the ground.
5.
Using two 12mm Bolts, attach Axle. Securely tighten using 12mm Ratchet and
Socket or like tools.
6.
Slide 1in. Washer onto each end of the Axle.
7.
Slide Wheel onto each end of the Axle.
8.
Securely tighten 18mm Nut to each Axle using 18mm Ratchet and Socket or like
tools.
9.
Slide Cotter Pin through hole on each end of Axle. Bend the ends of the Cotter
Pin to ensure the Cotter Pin will not slip out.
10.
Carefully stand the pressure washer up with the wheels and support legs
touching the ground.
ADDITIONAL INSTALLATION:
1.
Slide the Spray Gun & Hose Bracket through the holes on the Handle. Securely
tighten using the 14mm nuts and a 14mm Ratchet and Socket or like tools.
2.
Screw the Lance and Gun together to form Spray Gun. (Refer to picture below.)
3.
Place Spray Gun on the Spray Gun & Hose Bracket.
Spray gun
Gun wand
