Liebert Static Transfer Switch 2, Installation, Operation & Maintenance Manual, Page: 58 / 150

46 Installation Drawings
Figure 28 Control Wiring for the Network Interface Card (NIC) Option
STATICSWITCH2/CONTROLWIRE/PS213005-01
3/24/03
PS213005
CONTROL WIRING
NETWORK INTERFACE CARD OPTION
STATIC TRANSFER SWITCH 2
NETWORK INTERFACE
CARD (NIC) 416241GX
DATE
FILE NAME:
COLUMBUS, OHIO 43229 1050 DEARBORN DRIVE,
REV. NO. DWG. NO.
V CARMONA
REF. DWG. CHK BY DRAWN BY
AND LOCAL ELECTRICAL CODES.
LIMITED BY INTERNET STANDARDS.
6. ALL WIRING MUST BE IN ACCORDANCE WITH NATIONAL OF STATIC TRANSFER SWITCH FOR LOCATION OF NETWORK 5. REFER TO CONTROL CONNECTION LOCATION DIAGRAM SEPARATE FROM POWER WIRING. CONTROL WIRING RUNS 4. ALL CONTROL WIRING (BY OTHERS) MUST BE RUN SHOULD NOT BE COMBINED IN THE SAME CONDUIT. MANUAL FOR CONFIGURING THE NETWORK INTERFACE 3. REFER TO INSTALLATION, OPERATION & MAINTENANCE
1. WIRE SIZE AND TYPE: 10/100 BASE-T ETHERNET CABLE WITH RJ45 PLUG CONNECTOR. THE LENGTH IS
NOTES: INTERFACE CARD OPTION.
1
3
2
TB2
P18
J3
ETHERNET NETWORK
RJ-45 CONNECTOR
SEE NOTES 1 & 2
CUSTOMER SUPPLIED
INTERCONNECTING CABLE
+
-
CUSTOMER SUPPLIED
INTERCONNECTING CABLE TO MODBUS
SEE NOTE 2
WITH TWISTED PAIR CABLE #22 AWG MINIMUM. SIGNAL 2. MAXIMUM CABLE LENGTH 1000 FEET (300 METERS) VOLTAGE 5VDC, CURRENT 10mA.
RS-232 (DB9
CONNECTOR) FOR
SETUP ONLY. USES
STANDARD COMPUTER
SERIAL PORT CABLE
CARD (NIC).
1
"NO CUSTOMER
CONNECTION"
"NO CUSTOMER
CONNECTION"