Chapter 5: Installing a BioTek® BioStack™ Plate Stacker
32) If you need to adjust the height of the alignment pins, hold the threaded washer below the stand
and unscrew the knob until it comes off. While holding the threaded washer, screw the align-
ment pin in or out as needed to adjust the height and then replace the knob, but don’t tighten it.
33) Lift the front of the BioStack™ stand and guide the alignment pins into the holes in the locator
clamp.
Page 40
Summary of Contents for ODYSSEY Sa
