LGMG S0507SDTCE10, Operation And Maintenance Manual

Page: 67 / 79

Operation and Maintenance Manual of Aerial Work Platform
④
Press the enable key.
⑤
Raise the platform to the height about 2.3m away from the ground.
⑥
Press the drive function selector button.
⑦
Select one point (such as the touchdown point on the wheel) from the machine as the visual
inspection reference for the starting line and the finishing line.
⑧
Drive the machine at the maximum speed per hour and start to count when the reference point
passes the starting line.
⑨
Keep driving at the full speed and record the time when the reference point passes the finishing
line. Refer to the specification.
B-10
Test of driving speed-slow speed
1) This check shall be made once per 250h or per season, whichever is shorter.
2) The normal driving function is essential to the operation safety. With the driving function, a rapid
and stable response shall be given to the operator. No delay, vibration and abnormal sound shall
be outputted during the normal operation and driving process.
3) Be sure to complete the driving test on a solid and level ground without any barrier.
①
Draw two lines, spaced by 10m on the ground, as the starting line and the finishing line.
②
Switch the key switch to the platform controller and draw out the red emergency stop buttons from
the ground and platform controller.
③
Lower the platform to the folding position.
④
Press the driving speed selector button.
⑤
Select one point (such as the touchdown point on the wheel) from the machine as the visual
inspection reference for the starting line and the finishing line.
⑥
Drive the machine at the maximum speed and start to count when the reference point passes the
starting line.
⑦
Keep driving at the full speed and record the time when the reference point passes the finishing
line. The driving time shall not be less than 22.5s.
B-11
Hydraulic oil analysis
1) This check shall be made once per 250h or per season, whichever is shorter.
2) The replacement or test of hydraulic oil is essential to the equipment performance and service life.
The polluted hydraulic oil may affect the equipment performance and the equipment damage can
be caused, if it is used still. The frequent inspection is the must for the poor working environment.
3) Test if it is necessary to replace the hydraulic oil with an oil separator.
4) If the hydraulic oil has not been replaced for two years, test once per quarter. If the test fails,
please replace the hydraulic oil.
5) For test and replacement of hydraulic oil, please refer to E-1.
63