28
CLEANING THE SENSORS/CHARGING TERMINALS
Upper camera
sensor
• Do not clean the Robot Cleaner by directly spraying it with water, thinners, solvents, benzene, or any other liquids.
• Call the service center if the sensor or charging terminal is damaged.
Sensor and terminal damage can cause the product to malfunction.
• To clean the sensor/charging terminals, use the cleaning brush.
• Some models may not have a Camera Sensor, on the bottom.
There are sensors on the Robot Cleaner that detect obstacles, stairways and the
home station for charging the battery. In order to maintain the performance of the
Robot Cleaner, regularly clean the sensors and charging terminals as follows:
1. Turn off the power switch on the rear side of the Robot Cleaner. Injury can be
caused by the activation of the Robot Cleaner if the main power is not turned off.
2. Lay a smooth cloth on the floor, turn over the Robot Cleaner and put it on the cloth.
※
Please make sure to remove the dust bin before rotating the main body.
Otherwise, the dust in the dust bin may fall out.
3. Use a smooth cloth or cleaning brush to wipe the dust off each of the 3 cliff
sensors, camera sensors and ultrasonic sensors and the charging terminal as described below.
Charging terminals
Ultrasonic sensors
Obstacle detecting
sensor window Detecting
sensors of home station
& Receiving sensors of
remote controller
Cliff detection
sensors
Charging terminals
Lower camera sensor
(Optional)
Lens
Tip
