38
206-4256
Custom Master STB Setup (Cont.)
6. (PTC cloning only / Optional) Add Custom Channel and Aux Input
Labels: 2-5-4 + MENU Mode
2-5-4 + MENU Mode enables you to add/edit channel icons and custom
text labels in the PTC Channel Map once the Master STB Setup has been
transferred as described in the previous step.
Access the Installer Menu, and press
2-5-4
+
MENU
on the Installer
Remote. Add/edit custom text labels and/or change icons for the
Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 39). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press
MENU
to exit 2-5-4 + MENU Mode.
7. Verify the STB/display panel setup.
Make sure the STB/display features are set per your requirements. Also,
if cloning an auto-tuned/edited channel lineup, verify that the channel
lineup, channel icons, and custom text labels (as applicable) are correct.
8. (Recommended) Lock the channel lineup.
Access the Installer Menu. Set item
028 CH. OVERIDE
to
0
and press
OK
to lock the channel lineup and restrict access to the STB setup
menus. This step prevents end users from accessing channel settings
(i.e., the Channel Menu will be inaccessible/grayed out). Press
OK
again
to save your changes and exit the Installer Menu.
The Master STB Setup is now ready to be saved to a USB memory device
(TLX or TLL file) . See “Cloning Procedures” on pages 40 to 44.
After verifying the STB Setup, it is
recommended that you set Installer
Menu item 028 CH. OVERIDE to 0.
DIGITAL 19-3
WXYZ
MONO STEREO SAP
Custom text label “WXYZ” created
in 2-5-4 + MENU Mode.
028 CH. OVERIDE 000
(Continued from previous page)
5. (PTC cloning only) Transfer the auto-tuned/edited channel lineup (if
applicable) and setup menu settings to the PTC: 2-5-5 + MENU Mode
Note: This step is essential for successful cloning using a TLL
file. Without this step, the PTC will not contain any channels or
setup menu settings.
Note: The maximum number of channels (analog and digital)
that can be transferred to the PTC is 141. An attempt to transfer
more than 141 channels of any combination will result in a PTC
Channel Map of exactly 141 channels; any extra channels will
not be available in the PTC Channel Map.
a) After the STB channel lineup has been edited and channel label icons
added, tune to the channel (source) for which you wish to transfer the
setup menu settings.
b) Access the Installer Menu, and press
2-5-5
+
MENU
on the Installer
Remote to initiate the transfer of the Master STB Setup to the PTC. The
STB exits the Installer Menu and then tunes through the channels in the
channel lineup during the transfer. When the transfer is complete, the
STB tunes back to the channel that was tuned before the transfer began.