28
ENGLISH
Transportation (Power panel, Inverter)
• Precautions for handling
Do not let power panel and inverter tilted.
Be careful not to cause an impact to the components inside the control panel and the inverter as they are fragile.
Components inside the power panel and the inverter should not be soaked with water or oil.
Never fail to keep power panel and inverter indoors (For indoor type)
Do not load the goods on the top of the power panel and inverter.
Do not let any moisture generated inside the power panel and inverter.
Keep it in a dry place.
• Procedures for unloading
Hang the wire rope tightly.
Hang the wire rope with the degree less than 60°.
Adjust the crane hook at the center of the start-up panel to lift the power panel and inverter horizontally.
Lift the power panel and inverter slowly.
Tighten the wire rope and use a properly stranded wire rope.
Use a wire rope that can support the weight of the package enough.
Make sure to use 2 lifting hooks.
Moving the power panel and inverter stacked on each other or two or more sets simultaneously during unloading is
very dangerous. Never attempt to do so.
When pushing or pulling power panel and inverter, pay sufficient attention.
• Transportation by vehicles, etc.
1) How to uploading
Fix and stabilize the power panel and inverter when loading to prevent them from falling while transporting.
Do not load the start-up panel or any other goods on top of the power panel and inverter.
Use rope to fix the power panel and inverter to prevent them from moving or falling due to vibration.
Fix the starter by applying enough force to prevent the rope from loosening by impacts or vibrations when trans-
porting.
• Transportation by Using a Roller
Try not to transport by using a roller.
If inevitable, care shall be exercised for transportation of the system to prevent any impact to the control panel and
the operation panel.
• Transportation by forklift
Square bars with more than 60 mm thickness should be prepared when transporting the power panel and inverter
with a forklift.
Be cautious about the following when transporting by using a forklift.
Do not transport in stack.
Keep the valance of the power panel and inverter.
Transportation speed should be lower than 4 km/h (walking speed).
Use alternative transportation methods if there is a danger of disrupting driving of the forklift as the power panel
and inverter are too big.
Use forks length longer than the width of the start-up panel.
Be sure to use the forklift suitable for the weight of the power panel and inverter.
Summary of Contents for RCWFL Series
Page 40: ...40 ENGLISH 3 Control panel wiring diagram ...
Page 41: ...41 ENGLISH 3 Control panel wiring diagram ...
Page 42: ......