LG LRG30855S Series, Training Manual

Page: 45 / 74

GAS RANGE Page 44 of 72 TRAINING MANUAL
Remove the grates, burner caps, and burner heads. Then remove the brass
orifice (spud) in the chimney of each burner using a
9
/
32
” (7 mm) wrench or nut
driver.
NOTE:
The orifices have spring-loaded
retaining rings around the hex head to
hold the orifice in the nut driver during
installation and removal. A slight
amount of force is required to push the
nut driver down over the ring.
Install the LP orifice spuds into their
correct positions as described as
follows. A mark (I, II, or III) is engraved
on the top of the orifice to denote the
location of the orifice as shown in the
illustration.
The marks appear on both the LP and
Natural Gas orifices. The locations
indicated by the marks are the same
for both gasses.
The LP orifices are color coded as well as marked with an
L and the orifice size.
RIGHT FRONT 10,000 BTU Orange/Light Brown
LEFT FRONT 9,500 BTU Blue/Brown
LEFT REAR 9,100 BTU Orange/Green
RIGHT REAR 5,000 BTU Blue/Blue
CENTER 5,000 BTU Blue/Blue