LG LRG30855S Series, Training Manual, Page: 20 / 74

GAS RANGE Page 19 of 72 TRAINING MANUAL
WARMING DRAWER AND GASKET REPAIR
DRAWER REMOVAL
Pull the drawer out all the way to the
stop. There are tabs in the drawer rails.
Lift the left tab and push down the right
tab to pull the drawer off the rail.
DRAWER REPLACEMENT
To replace the drawer, place the rails
into the slides and push the drawer into
the range.
WARMING DRAWER TRACKS
Each track is attached to the range with
a Phillips screw and two tabs. To
remove the track, remove the screw
from the front of the track and pull the
slide out. Lift the track slightly and twist
it toward the center of the range to
disengage the front tab. Then pull the
track forward to release it.
WARMING DRAWER ELEMENT
Reminder! Unplug the range before
servicing the element! You’ll need to
remove the warming drawer to service
the heating element. Remove the two
T-15 Torx
®
screws that hold the
terminal cover. The element is attached
to the bottom of the range with six clips
held by ¼” hex-head screws.
WARMING DRAWER GASKET
The gasket is held by several small,
wire clips that are supplied already
formed into the gasket. Use needle-
nosed pliers to remove the clips. This
gasket forms a seal around the top and
sides of the drawer.