LG GBB940BMQZT, Owner'S Manual

Page: 10 / 68

10
EN
Reversible doors
Your appliance is designed with reversible doors,
do that they may open from either the left of right
hand side to suit your kitchen design
Required tools:
• 10 mm and 6 mm wrenches;
• 5 mm hex wrench;
•
Crosstip screwdriver
Do not lay the refrigerator down on the
floor.
Be careful to not drop the door while
disassembling and reassembling the
refrigerator.
• Move the plug (3) to the opposite side of
the upper cover (2).
NOTE
If you need to reverse the doors, you
should call a service technician. The
warranty does not cover door reversal.
Before reversing the refrigerator doors,
unplug the device and remove the food
and all removable accessories like
shelves and drawers from the
refrigerator.
•
Remove the upper cover (2) of the refrigerator
compartment door by removing the screws (1).
(1)
(1)
(2)
(3)
(4)
• Disconnect the connector cable (4).
•
After removing the screws (5), pull it
forward and lift the cover without
damaging the wire (6).
•
Remove the wire holder (7) and attach it to
the center of the cover (6).
(6) (5)
(7)
(9)
(5)
(8)
•
Pull the wire holder (8) out of the central
part of the cover (6) and attach it to the
opposite side of the cover (6).
•
Move the lead wires (10) to the opposite
side of the cover (6).
•
Install the plug (9) on the opposite side of
the cover (6).
• Avoid placing the unit near heat sources, direct
sunlight or moisture.
• Connect the power supply cord (or plug) to the outlet.
Don't double up with other appliances on the same
outlet.
• After connecting the power supply cord (or plug) to
the outlet, Wait 2-3 hours before you put food into the
appliance. If you add food before the appliance has
cooled completely, your food may spoil.
•
Models with handles should be located at least 55 mm
from the wall on the hinge side to open door by 90°.
• Allow over 55 mm clearance to the right, left, back and
top when installing.
•
To provide necessary air circulation, you should leave
enough space on each side, top and behind the
refrigerator-freezer.
• Set the limit stops in the upper corners of the back
plate of the device as shown in Fig.1 Stops (2) can be
found in the drawer inside appliance compartment.
– Fig.1 : Push Stopper (2) into part (1) until the end.
Push the refrigerator to the wall.
2
1
(5)
(5)