56
Maintenance
Replacing the lamp
When the service life of the projection lamp is
over, the icon suggests that the lamp needed to
be replaced will appear on the screen, and the
indicator for the replacement will flash yellow. If
so, you should immediately replace it with a new
one of the same model. The flashing time of the
replacement indicator is subject to the lamp mode.
To replace the lamp, follow the steps below:
1. Power off the projector and unplug the power
cord. Then let the project cool for at least 45
minutes.
2. Loosen the screws on the lamp cover and open
the cover.
3. Make sure the lamp is well protected and
remove three screws. Hold the handle and pull
out the lamp.
4. Install a new lamp with the same model and
tighten the three screws. Make sure the
installation is correct. Put lamp cover in place
and then tighten the screws.
5. Plug the AC power cord and power on the
projector.
As temperature inside the projector is high,
you should cool the projector for at least 45
minutes before you open the lamp cover.
When the lamp isn’t illuminated, it may indicate that the lamp has been damaged.
When you replace the lamp in a projector installed on the ceiling, you should stand beside
the lamp cover but not under it; for the broken glass may fall down to hurt you. To do that,
remove the lamp cover gently to avoid being hurt by the dropped glass. If glass drops into
your eyes or mouth, you should see the doctor immediately.
For the sake of safety, only use the lamp of
the same model. Never drop the lamp onto the
ground nor touch the glass bulb! The glass can
shatter and hurt.
Note
Note
Note
Lamp cover
Screw
Handle
Screw
Screw
Lamp
Indicator
LAMP indicator
lights red.
Lamp replacement icon
Replace the lamp