LG AB-W3067SA3, Installation Manual

Page: 21 / 37

REMOTE CONTROLLER INSTALLATION
ENGLISH
21
REMOTE CONTROLLER INSTALLATION
Point of remote controller
installation
- Although the room temperature sensor is in
the indoor unit, the remote control box
should be installed in such places away from
direct sunlight and high humidity.
Installation of the remote control
box
- Select places that is not splashed by water.
- Select control position after receiving cus-
tomer approval.
- The room temperature sensor of the thermo-
stat for temperature control is built in the
indoor unit.
- This remote controller equipped with liquid
crystal display. If this position is higher or
lower, display is difficult to see.
(The standard height is 1.5m high)
Routing of the remote control cord
- Keep the remote control cord away from the
refrigerant piping and the drain piping.
- To protect the remote control cord from elec-
trical noise, place the cord at least 5cm away
from other power cables. (Audio equipment,
Television set, etc)
- If the remote control cord is secured to a
wall, provide a trap at the top of the cord to
prevent water droplets from running.
Electrical wiring to the indoor unit
Put the installation paper on the place and
determine the position and height of the fixing
screws of the deluxe wired remote controller.
- Refer to the printed side of the installation
paper.
Remove the installation paper before installing
the remote controller so that it can fit into the
right place.
- When installing the deluxe wired remote
controller, do not install it so that it is buried
to the wall.
(This can cause error in the temperature sen-
sor)
- When installing multiple deluxe wired
remote controllers horizontally in one loca-
tion, leave a minimum distance apart
(20mm). (This can cause error in the temper-
ature sensor)
- Do not install the cable with a distance of 50
m or longer. (This can cause communication
error.)
- When installing the cable, check whether the
connector between the remote controller
and the product is installed properly. The
connector will not be connected when
installed in opposite sides.
Main board
CN REMO
Remote controller
CN REMO
The maximum length of the
cord is 100m. If the length of
the cord exceeds 50m, use a
wire size greater than 0.5mm
2
.
Make sure that wire and
terminal numbers are
matched on unit side
and remote controller
side.
The position of the fixing screws
Wall
Installation paper
Fixing the
remote controller
Fixing the
connecting cable