LG A2UW18GFA0, Svc Manual

Page: 26 / 113

- 25 -
Copyright ©2014 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Part 2 Functions & Controls
6.11 Two Thermistor Control
When pressing the button and button
simultaneously for more than 3 seconds, the system will be
entered into the installer setting mode.
- After entering into the installer setting mode, select the
thermistor sensor setting code value by pressing the
button.
* Thermistor sensor selection code value : 04
1
Select the desired setting value with the temperature up(
▲
),
down(
▼
) button.
2
When pressing the button, currently established
thermistor sensor location will be set up.
3
When pressing the button and button
simultaneously for more than 3 seconds after the setting
has been completed, the setting mode will be released.
- If there isn’t any button input for more than 25 seconds,
the installer setting mode will also be released.
4
OPER
MODE
OPER
MODE
Code value
*Setting value
01: Remote
controller
02: Indoor unit
03: 2TH
OPER
MODE
Value
TEMP
FAN
SPEED
OPER
MODE
❈
The function of 2TH has different operation characteristics according to the product.
<Thermistor Table>
This is the function to select the temperature sensor to judge the room temperature.
Temperature sensor selection Function
01 Remote controller Operation in remote controller temperature sensor
02 Indoor unit Operation in indoor unit temperature sensor
03 2TH
Cooling
Operation of higher temperature by comparing indoor unit's and wired remote
controller’s temperature.
(There are products that operate at a lower temperature.)
Heating
Operation of lower temperature by comparing indoor unit's and wired remote
controller's temperature.