Lexus NX350h 2022, Owner'S Manual

Page: 488 / 804

in vehicle-to-vehicle distance control mode, the vehicle speed may decrease to below
the set vehicle speed in order to maintain the distance from the preceding vehicle.
■
When the vehicle is stopped by system control during follow-up cruising
●
Vehicles without a head-up display: When the [+RES] switch is pressed while the
vehicle is stopped by system control, if the preceding vehicle starts off within approxi-
mately 3 seconds, follow-up cruising will resume.
Vehicles with a head-up display: When the [RES] switch is pressed while the vehicle
is stopped by system control, if the preceding vehicle starts off within approximately 3
seconds, follow-up cruising will resume.
●
If the preceding vehicle starts off within approximately 3 seconds of the vehicle being
stopped by system control, follow-up cruising will resume.
■
Automatic cancellation of vehicle-to-vehicle distance control mode
In the following situations, vehicle-to-vehicle distance control mode will be canceled
automatically:
●
When the brake control or output restriction control of a driving support system
operates (For example: Pre-Collision System, drive-start control)
●
When the parking brake has been operated
●
When the vehicle is stopped by system control on a steep incline
●
When any of the following are detected while the vehicle is stopped by system control:
•
The driver’s seat belt is unfastened
• The driver’s door is opened
•
Approximately 3 minutes have elapsed since the vehicle was stopped
● Situations in which some or all of the functions of the system cannot operate: → P.348
■
Dynamic radar cruise control system warning messages and buzzers
For safe use: → P.341
■
Preceding vehicles that the sensor may not detect correctly
In the following situations, depending on the conditions, if the system cannot provide suffi-
cient deceleration or acceleration is necessary, operate the brake pedal or accelerator
pedal.
As the sensor may not be able to correctly detect these types of vehicles, the approach
warning
( → P.491) may not operate.
● When a vehicle cuts in front of your vehicle or changes lanes away from your vehicle
extremely slowly or quickly
● When changing lanes
● When a preceding vehicle is driving at a low speed
● When a vehicle is stopped in the same lane as the vehicle
6-2. Using the safe driving support functions
486