Lexmark Optra Color 1200, Service Manual

Page: 62 / 245

Diagnostic Information
2-23
5050-001
Symptom Table
88 color Toner
Empty
The printer has detected that the specified toner
cartridge is completely out of toner. You must install a
new toner cartridge before you can continue printing.
If this message does not reset after you replace all the
toner cartridges, replace the toner remaining sensor
(11G0207) in the right sub-frame.
91 Fan Error
RIP Controller
Board Fan
1. Be sure connector C193 is properly connected to
the RIP controller card.
2. Replace the fan (11G0606) if necessary.
3. If you still have a problem, replace the RIP controller
card (11G0604).
2 xx Paper Jam /
Open Top Cover
The printer has detected a paper jam in the area
specified in the message. In some cases, the
Open
Top Cover
message alternates with the
Paper Jam
message to remind you to open the top cover and
remove jammed paper from inside the printer.
You must remove all the paper from the entire paper
path. Close the top cover and press Go to clear the
message. If the message does not clear, go to the
“Paper Jam Service Check” on page 2-30 .
Symptom Action
You cannot print color. Make sure the Color Correction menu item is not
set to Black & White.
Make sure the color print units are completely
installed in the printer.
Make sure the RIP controller card is completely
inserted in the printer and the thumbscrews are
securely tightened.
Go to the “Transport Belt/BUD Service Check”
on page 2-29 .
Transparencies curl
excessively. Make sure you’re using the recommended
Lexmark transparencies. Also be sure the paper
delivery is set to the rear exit.
Message Action