Lexmark Optra Color 1200, Service Manual

Page: 54 / 245

Diagnostic Information
2-15
5050-001
Print Jobs on Disk? Jobs that were spooled to the optional hard disk before
the printer was last turned off have not yet printed.
Press
Go
to print the jobs. Press
Return
or
Stop
to
delete the jobs from the disk without printing them.
Files Will be Lost.
Go/Stop? You have changed the Job Buffer Size setting from the
operator panel, and the printer must reformat the hard
disk to activate the change. If you press
Go , all files
currently stored on the disk will be deleted. Press
Return or Stop to cancel this operation.
Invalid Font Data The printer has detected an incompatibility between
the font data and the firmware. You must download
compatible font data to flash memory before the
printer can return to the ready state.
Invalid Network
x
Code
The code in the specified network adapter has not
been programmed or is invalid. You must download
valid code to the network adapter before the printer
can return to the ready state.
30 color Print Unit
Missing
The specified print unit (Cyan, Magenta, Yellow, or
Black) is not installed in the printer. Insert the print unit
and close the top cover to clear the message.
33 Tray
x
Configuration Error
The printer has detected a tray with the rear paper
guide in the wrong position. When loading A4 and
letter size paper, make sure you place it in the tray with
the long-edge of the sheet next to the front of the tray.
Position the rear paper guide correctly for the paper
size, then insert the tray in the printer.
35 Res Save Off
Deficient Memory The printer lacks the memory needed to enable the
Resource Save function. This message usually
indicates that too much memory is allocated for one or
more of the printer link buffers.
To disable Resource Save and continue printing, press
Go
.
To enable Resource Save after you get this message:
• Set the link buffer for each interface to Auto, then
exit the menus to activate the link buffer changes.
When the
Ready
message is displayed, enable
Resource Save from the Setup Menu.
• Or, install additional printer memory.
Message Action