Lexmark 4310-VW SERIES, Service Manual

Page: 29 / 72

Diagnostic information
2-10
Lexmark S800 Series
1217 Printhead Temperature Error There is a problem determining
temperature.
Technical Support Center:
Check and clean the contacts. If the
problem persists, then replace the
printhead.
Service:
Check and clean the contacts. If the
problem persists, then replace the
printhead.
1218 Serial Flash Error Invalid parameters have been
passed to ReadFlashPage.
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the All-In-
One.
Service:
Replace the system board. See
“System
board with media sensor, cable, and
spring removal” on page 4-21
.
1219 Undefined Signal Error Microprocessor has
encountered a bad signal
(other than an abort, illegal
instruction, or arithmetic
exception). Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See “System
board with media sensor, cable, and
spring removal” on page 4-21
.
120A Undefined Error The microprocessor has
encountered an abort or
undefined instruction. Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in, and turn the power on. If the
problem remains, then replace the All-In-
One.
Service:
Replace the system board. See “System
board with media sensor, cable, and
spring removal” on page 4-21
.
120B Address Error Firmware attempted to access
invalid address space.
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in, and turn the power on.
Service:
Replace the system board. See “System
board with media sensor, cable, and
spring removal” on page 4-21
.
Error
Code
Name Description Action