Lexicon PCM 81 - REV, User Manual

Page: 45 / 174

Lexicon PCM 81 User Guide
2-24
Compare Whenever you edit a PCM 81 effect from the front panel, the LED in the
Compare button will light. This lets you know that the effect has been altered
since the last store operation, and that the edit compare function is active.
Whenever this light is on, you can press Compare to hear the original version
of the effect. A message will be displayed to inform you that the stored version
of the effect is being loaded. Although this message is only displayed briefly, the
Compare LED will flash to let you know the effect you are hearing is the stored
version. While Compare is on, you can use the SELECT knob and the Up and
Down buttons to view parameter values in the stored effect.
Press Compare again to reload your edited version. Another message will be
displayed, and the Compare LED will stop flashing and remain lit until you store
your edited version, or select and load another effect.
Note: Altering parameter values with patched sources other than ADJUST will
not light the LED.
Bypass
If you press Compare while the light
is on, a message will be displayed ...
stored effect active
Compare is on
...and you will hear the original (stored)
version of the effect. You can display the
parameter values of the stored effect with
SELECT and Up and Down.
As soon as you alter an effect,
the Compare light will go on.
The Compare light is off until
you make changes to an effect.
The Compare light will flash until you press
Compare again to reload the edited version of
the effect. While Compare is on, you cannot
select another effect.
The front panel Bypass button is always active, and will turn on the type of
bypass (AllMute, InputMute, OutputMute, or Bypass) selected in Control
Mode 1.3.
When you press Bypass, the button LED will light and a message will be
displayed to inform you that bypass is on. The display message will also indicate
the type of bypass which is in effect. Press Bypass again to turn both the LED
and the bypass condition off. A brief display message will inform you that bypass
is off.
Press and hold Bypass to display the current state and type of bypass.