Lexicon PCM 81 - REV, User Manual

Page: 136 / 174

4-9
The Presets
2.7 BandEkoSweep ADJUST: Mstr Fbk 0–100
A variation of BankEko Rvb. In this preset, the center frequency of the band pass filter is
swept by the LFO producing echoes of shifting colors. Reverb and diffusion are turned
off, but you can add them in from the Soft Row. ADJUST controls master feedback for the
left and right delays.
2.8 LFO EQ Echo ADJUST: LC Depth 0–100
A stereo rhythmic effect created by modulating low cut and high cut filters with the LFO
sine and cosine waves. Interesting on rhythm tracks and individual instruments. ADJUST
controls the depth of the low cut modulation.
2.9 Chase Echo ADJUST: ChaseRate 0–100
This is LFO EQ Echo with panning added to the filtered delay outputs. ADJUST controls
the pan rate.
3.0 Panned Dlys ADJUST: Mstr Fbk 0–100
In this effect, a pair of delays are panned to produce echoes that drift across stereo space.
ADJUST controls the feedback of both delays. More goodies await you in the Soft Row.
3.1 X-Pan Delays ADJUST: Mstr Fbk 0–100
The outputs of the delay pair are cross-panned in this effect. Mono material will produce
echoes that repeat, but remain in the center. Stereo material will slowly swap left and right
as it repeats. Use ADJUST to set the feedback for both delays.
3.2 Dly>EQ>Pans ADJUST: Mstr Fbk 0–100
The input signal is split into two frequency bands by this effect. The two bands are then
sent through two different rhythmic delays whose outputs are panned in opposite
directions. This effect deconstructs the tone of input material, except when the panning
and delay rhythms align in the center of the stereo field. Try it with a drum mix or other
broad band material. Use ADJUST to set the feedback for both delay voices.
3.3 Ekoz 4 Drums ADJUST: FX Mix 0–100
This preset is a space setter for percussive instruments. It combines a short plate reverb
effect with four high density echoes which are highly diffused. ADJUST varies the amount
of delay effect to reverb effect.
3.4 Haas PanKnob ADJUST: L=0, R=127 0–127
A panner that uses the slight differences in left and right channel delay to produce panning
without changing relative levels. Use ADJUST to pan from left to right.
3.5 Dial a Delay ADJUST: Delay 0–100
This one is your basic delay. Use ADJUST to dial-in up to 2.5 seconds of stereo delay.
The Soft Row will take you beyond the basics, with parameters for reverb design, EQ and
feedback.
3.6 PrecisionDly ADJUST: L ms/100 0–100
Use this preset if you need precise alignment of left and right channel audio. ADJUST
allows you to offset the left channel by up to 1 ms in 100 increments. The Soft Row
contains two sets of additional delay controls for the left and right channels, each with 1ms
resolution, as well as independent level and panning controls.
Rhythmic Echo and
Delay Effects
(P1 0.0 – P1 3.6) cont'd.