Lexicon PCM 81 - REV, User Manual

Page: 35 / 174

Lexicon PCM 81 User Guide
2-14
To load a specific Program Chain, without sending the PCM 81 a MIDI Program
Change message, use ADJUST to display the desired chain number.
3.4 Automation
This control is provided for communication with one or more additional PCM 80s
or PCM 81s. Select On to have values resulting from front panel operations sent
out as SysEx messages. Press Load/
✱
to select the ID (0-126 or All) of the
target PCM 81(s).
Automation sends all MIDI commands in PCM 80 format, which is also recog-
nized by the PCM 81. As the PCM 80 has only four Banks (0-3), it cannot load
programs from PCM 81 Banks 4 and 5 in Automation mode.
3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST)
If Transmit is set to On these four controllers can transmit MIDI controller
messages. Press Load/
✱
to cycle through the controller selections. Use
ADJUST to select the MIDI Controller message to transmit.
3.6 Int Clock
You can choose to have the PCM 81 transmit MIDI Clock at the current tempo
rate by setting this control to On and Tempo mode Source (0.2) to Internal. If
this control is set to Off, MIDI Clock will not be transmitted.
3.7 SysEx
This control is provided for communication with one or more additional PCM 81s
or computer editor software. On (the default setting) allows SysEx messages
to be received by the PCM 81. Press Load/
✱
to select device ID (0-126 ).
3.8 Dump
Press Store to configure the PCM 81 to execute MIDI dumps of single effects,
banks, maps, chains, or setups.
With the exception of Setup Dumps, all dumps are transmitted in PCM 80 format,
which is also recognized by the PCM 81. You can dump from the front panel of
either unit to the other. As the PCM 80 has only four Banks (0-3), references to
Banks 4 and 5 will be ignored when transmitted to a PCM 80.
3.9 Dump Speed
Turn ADJUST to select dump speeds of Slow, Medium or Fast to achieve
compatibility with the connected MIDI device.
MIDI Pgm Change
3.3
✱
Chain 3