Levolor Corded Lift Control, Installation Manual

Page: 145 / 180

RESETTING THE SHADE (IF NECESSARY)
Basic Reset
The basic reset is used to reset the shade’s travel limits.
Bottom-Up Shades:
1. Press and hold the manual control button for 6 seconds. The shade will
move slightly.
2. Release the manual control button. The shade will raise to its fully open
position to set the upper travel limit, then lower to the fully closed position
to set the lower travel limit. The shade will move slightly one more time to
indicate that the travel limits have been reset.
Resetting Shade Programming
This reset erases all shade programming from memory, including group assignments,
preventing any input device from operating the shade. Its primary use is during
installation to correct group and network assignments. This reset does not affect
travel limits.
1. Press and hold the manual control button for 12 seconds. The shade will move
slightly once after 6 seconds, then again after 12 seconds. Release the button.
2. Refer to “Joining a Shade to a Group” in the remote guide to program the shade
to a group.
Remove
Bracket
Back of
Shade
Headrail
Bottom
Tab
REMOVING THE SHADE (IF NECESSARY)
• Lower the shade approximately 4".
• While holding the headrail, push
back on the bottom tab of the
installation bracket to release
the bottom edge of the headrail.
• After releasing the bottom edge,
roll the back of the headrail
down and out from the bracket.
Battery-Powered Motorized Operating System
OPERATION | UNINSTALL
25