Levolor Corded Lift Control, Installation Manual

Page: 131 / 180

Front of
Headrail
Battery Wand Clip
Snap in
Place
Back of Shade
Socket
Tab
Slot
Cap
Latch
Battery
Pack
Squeeze
INSTALLATION
Battery-Powered Motorized Operating System
STEP 3: INSTALLING BATTERIES INTO THE BATTERY WAND
• Squeeze the cap latch to release the cap
• Remove the cap from the battery wand
• Install the batteries according to the instructions on the battery pack label
(AA Alkaline batteries are recommended. Lithium and rechargeable batteries
are not recommended.)
Skip this step if your shade will not have an attached battery wand
• Attach the battery wand clip to the headrail. Make
sure to position the clip so that the battery wand
will be between installation brackets
• Hook the battery wand clip onto the
back channel of the headrail
• Rotate the clip down
until it snaps into place
STEP 4: MOUNT THE BATTERY WAND INTO THE
BATTERY WAND CLIP
• Align the battery wand with its socket
toward the motor side end cap.
• Push the battery wand straight up into
the battery wand clip until it snaps into
place. Check to make sure the battery wand is secure.
IMPORTANT: Be sure the cable does not become pinched by the battery wand
clip during installation. Damage or overheating of components could result.
STEP 5: PLUG THE POWER CABLE INTO THE BATTERY WAND
• On the back of the headrail, connect the power cable (coming
from the shade) into the socket on the battery wand.
Connect the Power Source
NOTE: When power is connected to the motor, a green LED inside the manual control
button housing will flash to indicate the shade is ready for operation.
Battery Wand Clip
High Mount (Standard)
11